Jump to content

Lights!


Recommended Posts

If u are serious, ATI power module and nothing less than 8 tubes. Ex successful reefers used 10 to 12 tubes. They also placed them very near water level. Your budget may need to revise. If budget, go for DE lighting, it's within yr budget and with tubes, I think.

Tank : 4 X 2 X 2 with low iron front panel and external overflow

Skimmer : BK SM200 with waste collector

Return Pumps : Red Dragon 6m3 and Ehiem 1262

FR : 2 X Deltec 509 & powered by AB2000

Nitrate Filter : Deltec NF 509 and tee off from AB2000

Calcium R'tor : Deltec PF 501 with RM secondary chamber

Kalkwasser R'tor : Deltec KM500

Chiller : Pansonic 1 HP Compressor with 20m titanium Coil

Wave Makers : 4 X Tunze 6055 with 7096 & Vortec MP40w

Controller : GHL Profilux

Lighting : ATI Powermodule 10 or 8 tubes

Water Top-up : Water Top-Up tank powered by Tunze Osmolator

External Monitor : American Pinpoint pH and Temp. Monitor for main tank and GHL Profilux Controller to measure temp, pH, Redox

Ozonizer : Sander C50

UV : Corallife 6x

Algae Scrubbler

Link to comment
Share on other sites

  • SRC Member

U might wanna consider MH for Long-term cost efficiency. Watt for watt, MH gives more bang. Heat issue is overdone... Place it 30cm above water and it's fine. Get the most natural look, with shimmer like sunlight on reef.

Link to comment
Share on other sites

MH , T5 are all proven.

But efficiency of each is different.

LED is still in discovery stage. So many factors is overlook .

Today most decent LED light set come with all the control you need.

Whether is timing or intensity, dawn,dusk, sunrise,sunset, lunar cycle are

becoming standard .

Some even come with wifi remote and most can be daisy chain up to at

least 30 units.

Only the very cheap model just come with standard on/off .

Shop around on internet. You will see what is common in market today.

6.5 * 2 * 2 + 3.75 * 1.5 *1.5,(Decomn on 14/9/08)
4*2*2 + 2.5*1.25*1.25 (Decomn on 1/8/09)
5*2*2 (Fully LED light system, 140 3 watt SSC leds with 60 degree lens)(Decomm)
2.5*2*2(Fully LED Light System,96 3 watt SSC leds with 60 degree lens)(Decomm)

5*2.5*2(LED only)

Eheim return 1 * pump

1 HP Daikin compressor with cooling coil
2 Jebao OW40, 1 ecotech MP40,
1X6085 Tunze wm,

1 CURVE 7 Skimmer

  1 DIY 80 led control by Bluefish mini 

1 radion XR30W G2, 2 Radion XR15G3

Sump area lite by 5 ft T5 , 6 * SSC 3 watt red LED for refugium

1 Full spectrum E27 led light

1 CR control by bubble count

Start No Water Change since 1st Dec 2016

Add new 2.5x2x 1.5 ft 

 nLekOfpYts.jpg
[/quote]


 

Link to comment
Share on other sites

  • SRC Member

A 150w led run thr same wattage as a 150w mh BUT a good 150w led has much higher PAR then a 150w mh.. Led is good but has yet to be entirely proven.. Ati is definitely proven and prices are getting very attractive from aquamarin

EvolutionZ's Floating Reef:

(Decommed) EvolutionZ's 4ft shallow Mixed Reef Build :

Link to comment
Share on other sites

If u consider T5 then go for a T5 lightset from an established brand.

The electronics component in there together with the ability to control will greatly affect the light coming out of the same tube. Of cos a good set of tubes would also make a huge difference.

Link to comment
Share on other sites

  • SRC Member

I am not sure. There may be some efficiency loss. why buy a 150w set and run it at less than its full potential though? Also with MH, u replace one or two bulbs every 5,000 hrs or so, compared with 8 T5 tubes every 3,000 hrs. So MH much cheaper in long run. I don't know the replacement cost of LEDs, but the drivers can't be cheap. I think they are also not as robust as MH or T5 on the whole.

Link to comment
Share on other sites

  • SRC Member

MH has been around a long time. Even before T5s. Simple research will tell u how much wattage u need. otherwise, T5 is good alternative. but I personally find LED too artificial... the same as the new LED TVs... everything appears like CGI.

Link to comment
Share on other sites

  • SRC Member

422 full SPS for all 3 kind of lighting my recommandation will be :

1) led : maxspect razor 300w (budget)

Or 2x ai hydra 52 (deep pocket)

2) t5 : ATI Sunpower/power module 8/10 tubes.

3) Mh : probably will need 2x 250w and also 4 tubes t5 (2 front 2 back)

4) t5 + led : ati powermodule led hybrid.

The mh will produce not only alot of heat got your tank, but for you as well. Option 4 would be the best choice out there IMO.

EvolutionZ's Floating Reef:

(Decommed) EvolutionZ's 4ft shallow Mixed Reef Build :

Link to comment
Share on other sites

  • SRC Member

Yes indeed. Free bulbs too. But take note, if ur a hardcore SPS keeper, youll have to change your bulb every 10 months. And 12 months if u wanna save some money. Thats 180 bucks every year for bulb change (8 tubes). And this only applies for ATI Light set.. For lousy set like aquazonic, bulb change have to be made sround every 6-8 months.

EvolutionZ's Floating Reef:

(Decommed) EvolutionZ's 4ft shallow Mixed Reef Build :

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



×
×
  • Create New...