When you are experiencing difficulty in removing the pump due to new O-ring, you may need a long nose plier or something that can help turn and release the pump
Good day,
I have a 4-5 months old fresh water tank setup for sale at 4.8K (neg), can be use for marine setup
Pls see attached for equipment list.
Interested pls pm.
Thank you
Disclaimer - Reefers who are not competent in DIYing electrical stuff, please consult a friend or LFS. The diagram posted is solely for reference and discussion only, I shall not be held responsible for mishaps or negligence on your part.
Hmmm I ll chk the manual and get bk on this.. It had been long awhile
If I remember correctly the diff determines the cut off and kick in temp . Ie if temp set at 26 deg and diff is 2, the controller will kick in at 28 deg and cut off at 26. Btw the temp controller should have a decimal, so u can have more precise controlling.
Actually the controller do have a 8A relay which can handle about 1760watts. So it shouldn't be a problem if your chiller is of lower HP... if too high I'd add a higher Amp relay, which need another set of wiring method.
2 ft Twin tube housing - $90 (brand new but no tubes, no reflectors)
2 ft Quad tube - $160 (brand new but no tubes, no reflectors)
Mh housing with 400w eballast = $180 (Brand new, no bulb)
yup..those points brought up was also considered.... all these will be controlled by a relay with and float switches...
Was a long time ago since i last do all these DIY stuff and lost my drawing ,.need sometime to figure them again..