Jump to content

Corals perishing


dnwolf
 Share

Recommended Posts

  • SRC Member

Thanks for the advise ReefFish.

I'm facing a similar issue with my SPS bleaching and I think you just helped solved my problem (or rather, reaffirm my conclusion)

I've dumped all my carbon and Seachem Phosguard while doing a WC yesterday, and I'm dosing RedSea Reef Energy A & B excessively.

Hope to bring my NO3 and PO4 up soon.

Sometimes the good guys gotta do bad things to make the bad guys pay. - Harvey Specter

Link to comment
Share on other sites

  • SRC Member

I don't think i would ba .. Don't wanna waste the time i spent last time .. I'll let the tank settle down and remove that little crab ~

Dude I think its better to do a restart since your tank is only 1 month old.

Sometimes the good guys gotta do bad things to make the bad guys pay. - Harvey Specter

Link to comment
Share on other sites

I don't think i would ba .. Don't wanna waste the time i spent last time .. I'll let the tank settle down and remove that little crab ~

Not sure if it is a good suggestion . You might want to restart your tank ? With proper procedure from curing rock to cycling your tank for at least a month ?

Dude I think its better to do a restart since your tank is only 1 month old.

Restarting may save lot of your money in buying or paying for solution.

Long term wise it will save time and effort .

The choice is yours :)

[DECOMMEND]

Tank : 24" x 12" x 15" Acrylic Gex Tank

Lightings : Maxspect Razor 120W , Maxspect G2 160W ( Sold )
Skimmer : Red Sea Prizm
Dosing : Brightwell Aquatics Microbacter7,
Brightwell Aquatics Biofuel, Florida Aqua Farms It's Clear,

Florida Aqua Farms Coralline Stimulator.

Wavemaker : Tunze Nanostream 6015

Link to comment
Share on other sites

  • SRC Member

Just restart then do water changes 2-3 times a week Siphon all the debris as u change water. Siphon off the algae when u change water so that the algae will not float around and trap in rocks. .etc. Dont overstock. .. Go back to the basic school of Reef keeping..

Link to comment
Share on other sites

The tank did went to 0 ammonia 0 nitrite and 0 nitrate before i added in some mushrooms and hermits.

Anyways i caught that crab but i found a smaller one ( its white in color so it might be just a molt ) on some other rock .

I do see some corraline coming back to live from bleaching on a piece of live rock .

Havent tested for ammonia , nitrite and nitrate but I assume that they are all in acceptable levels as my snails are still grazing on the rocks .

Link to comment
Share on other sites

Those mushrooms still looks like .. nevermind ... However the other rock of mushroom looks fine . I think i would remove the unhealthy ones next week if they do not get better .

Planning to let my tank mature for around 2 months before i add in LPS corals .

Link to comment
Share on other sites

K the ammonia spiked <0.25 ( the color was darker than 0ppm but lighter than 0.25ppm )

The nitrites are 0

The nitrates are 10

I think the ammonia spike could be due to table shrimp i placed inside a trap as well as a mini die off as i added a some live rocks into the system yesterday

Link to comment
Share on other sites

  • SRC Member

If you did a proper cycle there should not be a spike in ammonia over a few LS dieoffs. At the end of a full cycle, your nitrates should increase. Your nitrates stayed at 0 which means that your cycle was incomplete. I know this sounds harsh dude, but these problems you're facing are the results of not cycling your tank.

Sometimes the good guys gotta do bad things to make the bad guys pay. - Harvey Specter

Link to comment
Share on other sites

I think your photo period from 11am to 9.30pm is quite long. You can try reducing to 8 or 7 hours to prevent algae growth.

Tank: 3.5ft x 2ft x 1.5ft, 12mm

Sump: 3ft

Skimmer: Bubble Magus Curve 7

Lightings: Maxspect 15000k

Return Pump: Eheim 1252

Wavemaker: Jebao WP25, Jebao RW-8

Link to comment
Share on other sites

  • 2 months later...

I think ur prob is from using tap water and not di water.

Those looks like an infestation of hair algae, nitrates and phosphates probably sky high that's why ur mushrooms don't look good.

Ur using api test kits? Pretty sure the salifert ones would give u a sky high reading.

Restart properly, and use di water.

Link to comment
Share on other sites

  • SRC Member

hi bro

my suggestion is for a start since you are using the cheap hydrometer like me!! change your salinity to 1.020. the meter is just cheapo plastic so try a calibrated one n u will see wat i mean

Sent from my iPhone using Tapatalk

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



  • Join us on the largest Reefing community in Asia!

    Sign up and share your reefing journey with us, make friends and get helps from the community .

     

  • Topics

  • Latest Update

    1. 0

      wtb nudibranch

    2. 0

      EXTRAWD - Agen Slot88 Terpercaya Paling Menguntungkan

    3. 0

      EXTRAWD - Agen Slot Gacor Terpercaya Paling Menguntungkan

    4. 0

      wts zoas

    5. 0

      EXTRAWD : Akun Demo Slot Pragmatic Play Gratis Gampang Maxwin x1000

×
×
  • Create New...