Jump to content

advise needed on pumps


sinner
 Share

Recommended Posts

  • SRC Member

hi guys i need advise on the proper pump to be used on a 3foot tank as my sand bed and rocks have been collecting dust... currently using a 1500l pump from my side overflow filter... should i change or leave it as it is and wait for a miricle? :( if i should change one i'll appreciate more if a make and model is supplied...

Link to comment
Share on other sites

  • SRC Member
hi guys i need advise on the proper pump to be used on a 3foot tank as my sand bed and rocks have been collecting dust... currently using a 1500l pump from my side overflow filter... should i change or leave it as it is and wait for a miricle? :( if i should change one i'll appreciate more if a make and model is supplied...

Add another powerhead inside the tank to circulate and stir the water a bit lor. I using a Eden 228 PH bought 2ndhand, so far doing a good job. But my return pump,ehiem 1260, can deliver 2500L/Hr. So far can observed the slight current even along the sand bed. My tank is 3ft x 1.5ft x 2.5ft. with 6inch DSB.

Cheers,

James

Reviving my reef tank :

Crystal glass 53" x 22" x 17" rimless (inclusive of 12"x22"x17" IOS)

Life Reef HVS3-24 with mazzei venturi

ATI Sunpower 8 x 39w T5 (4 x Blue plus, 2 x Aqua blue special, Coral plus)

ZET Light 3 x 3w LEDs moonlight

Arctica 1/3 Hp + 1/4 Hp back up

Vortech mp40w x 3 + Jebao wp25

Eheim 1264 x 3 + water blaster 5000

Vortech back up battery

TLF-150 + Rowaphos

Activated carbon

Kamoer 3 channel + CaCl2 + NaHCo3

150L Refugium with DSB, miracle mud, cheato

2ft T5 x 2 light tubes for refugium

Link to comment
Share on other sites

  • SRC Member

you're using the 1260 as a return pump from the sump? actually i prefer the pump to be in the filer compartment (my side overflow filter) as i'm afraid things might get sucked into the powerhead which my ex anemone did :(

Link to comment
Share on other sites

  • SRC Member
you're using the 1260 as a return pump from the sump? actually i prefer the pump to be in the filer compartment (my side overflow filter) as i'm afraid things might get sucked into the powerhead which my ex anemone did :(

Wont one lah, you put the PH near to the surface of the water and remove away the unsightly suction sponge below the PH. The rotating PH will sweep the water thus recreating some current. Best is aim the PH flow towards ur return flow so both current will cross at each other.

Cheers,

James

Reviving my reef tank :

Crystal glass 53" x 22" x 17" rimless (inclusive of 12"x22"x17" IOS)

Life Reef HVS3-24 with mazzei venturi

ATI Sunpower 8 x 39w T5 (4 x Blue plus, 2 x Aqua blue special, Coral plus)

ZET Light 3 x 3w LEDs moonlight

Arctica 1/3 Hp + 1/4 Hp back up

Vortech mp40w x 3 + Jebao wp25

Eheim 1264 x 3 + water blaster 5000

Vortech back up battery

TLF-150 + Rowaphos

Activated carbon

Kamoer 3 channel + CaCl2 + NaHCo3

150L Refugium with DSB, miracle mud, cheato

2ft T5 x 2 light tubes for refugium

Link to comment
Share on other sites

  • SRC Member

wat about the size? does it look unslightly? keke if it's too big then no point already... wan my tank to look neat... thought of the tunze but replies from fellow reefers here... it's an overkill for a 3foot :cry:

Link to comment
Share on other sites

  • SRC Member
wat about the size? does it look unslightly? keke if it's too big then no point already... wan my tank to look neat... thought of the tunze but replies from fellow reefers here... it's an overkill for a 3foot :cry:

The eden ph is just 5" x 2" x 3" , put in the corner with the black oyama sticker at the back of tank is almost unseen.

Cheers,

James

Reviving my reef tank :

Crystal glass 53" x 22" x 17" rimless (inclusive of 12"x22"x17" IOS)

Life Reef HVS3-24 with mazzei venturi

ATI Sunpower 8 x 39w T5 (4 x Blue plus, 2 x Aqua blue special, Coral plus)

ZET Light 3 x 3w LEDs moonlight

Arctica 1/3 Hp + 1/4 Hp back up

Vortech mp40w x 3 + Jebao wp25

Eheim 1264 x 3 + water blaster 5000

Vortech back up battery

TLF-150 + Rowaphos

Activated carbon

Kamoer 3 channel + CaCl2 + NaHCo3

150L Refugium with DSB, miracle mud, cheato

2ft T5 x 2 light tubes for refugium

Link to comment
Share on other sites

  • SRC Member

The eden ph is just 5" x 2" x 3" , put in the corner with the black oyama sticker at the back of tank is almost unseen.

I have attached a pic for it.

post-17-1075269982.jpg

Cheers,

James

Reviving my reef tank :

Crystal glass 53" x 22" x 17" rimless (inclusive of 12"x22"x17" IOS)

Life Reef HVS3-24 with mazzei venturi

ATI Sunpower 8 x 39w T5 (4 x Blue plus, 2 x Aqua blue special, Coral plus)

ZET Light 3 x 3w LEDs moonlight

Arctica 1/3 Hp + 1/4 Hp back up

Vortech mp40w x 3 + Jebao wp25

Eheim 1264 x 3 + water blaster 5000

Vortech back up battery

TLF-150 + Rowaphos

Activated carbon

Kamoer 3 channel + CaCl2 + NaHCo3

150L Refugium with DSB, miracle mud, cheato

2ft T5 x 2 light tubes for refugium

Link to comment
Share on other sites

  • SRC Member
The eden doesnt work very well mine jammed and must be serviced regularly.

Sinner can show a pict of your tank? I dont understand your tank layout. Sorry.

:peace: hi riot thanks for the interest in helping me, i'll try my very best to get the camera working and post it online :)

Link to comment
Share on other sites

  • SRC Member

:peace: hi riot thanks for the interest in helping me, i'll try my very best to get the camera working and post it online :)

You can open up the bottom of ur eden to check the gear if it stop rotating, something must have stuck in between the gears.

Test!

Cheers,

James

Reviving my reef tank :

Crystal glass 53" x 22" x 17" rimless (inclusive of 12"x22"x17" IOS)

Life Reef HVS3-24 with mazzei venturi

ATI Sunpower 8 x 39w T5 (4 x Blue plus, 2 x Aqua blue special, Coral plus)

ZET Light 3 x 3w LEDs moonlight

Arctica 1/3 Hp + 1/4 Hp back up

Vortech mp40w x 3 + Jebao wp25

Eheim 1264 x 3 + water blaster 5000

Vortech back up battery

TLF-150 + Rowaphos

Activated carbon

Kamoer 3 channel + CaCl2 + NaHCo3

150L Refugium with DSB, miracle mud, cheato

2ft T5 x 2 light tubes for refugium

Link to comment
Share on other sites

  • SRC Member

I'm using 2 of these in my 422 tank. Pump I'm using a different brand. Cheap, low wattage and powerfull. You can break the flow using a modular hose split into 2.

Acrylic Aquarium Filtering Systems

Acrylic tanks, sumps, protein skimmers, overflow box, refugium, calcium reactors, zeovit reactors and many more...

Our New Address:

Blk 9003, Tampines St. 93,

Tampines Industrial Park A,

#03-134, Singapore 528837

(Located behind Tampines SAFRA)

Contact Nos.

(Tel) +65 9298 9489

(Fax) +65 6588 4711

Please direct your...

Email me : info@iaquatic.com

*Please do not send PM's to us. Thank you

Link to comment
Share on other sites

  • SRC Member

Here is picture of the pumps.

post-17-1075429117.jpg

Acrylic Aquarium Filtering Systems

Acrylic tanks, sumps, protein skimmers, overflow box, refugium, calcium reactors, zeovit reactors and many more...

Our New Address:

Blk 9003, Tampines St. 93,

Tampines Industrial Park A,

#03-134, Singapore 528837

(Located behind Tampines SAFRA)

Contact Nos.

(Tel) +65 9298 9489

(Fax) +65 6588 4711

Please direct your...

Email me : info@iaquatic.com

*Please do not send PM's to us. Thank you

Link to comment
Share on other sites

  • SRC Member
I'm using 2 of these in my 422 tank. Pump I'm using a different brand. Cheap, low wattage and powerfull. You can break the flow using a modular hose split into 2.

Ian, where can i get the pumps? U refer to the one Yazid Posted right?

thks

or shld i ask Yazid? ... where can i get them?

thinking of using one for closed loop ...

mydog.gif
Link to comment
Share on other sites

  • SRC Member

Hi Nicky,

I'm not using Yazids type. its another brand. I got it at Pasir Ris farm. Not sure whats the exact address. Sorry. The brand is funny. 'Jalli' :lol: But it feels solid and the cooling fan is in built.

Acrylic Aquarium Filtering Systems

Acrylic tanks, sumps, protein skimmers, overflow box, refugium, calcium reactors, zeovit reactors and many more...

Our New Address:

Blk 9003, Tampines St. 93,

Tampines Industrial Park A,

#03-134, Singapore 528837

(Located behind Tampines SAFRA)

Contact Nos.

(Tel) +65 9298 9489

(Fax) +65 6588 4711

Please direct your...

Email me : info@iaquatic.com

*Please do not send PM's to us. Thank you

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



×
×
  • Create New...