Calling all Macro Skimmer User

[dradttg]

Dear all,

Please tell me if I should set the water level at A or B?

Thank you.

[dradttg]

Anyone??

[cowgum]

I prefer it at B for a wetter skimate

[somebody]

yep... it'll depend on the skimmate that you are looking for...

A - drier skimmate

B - wet skimmate

[dradttg]

Thanks. Anyone of you try running a Ozonizer with it??

[SoTongBall]

macro skimmer can be run with ozone, did wrote to the manufactural last year to confirm it. I presume it will be the same for the new model.

marco

Did feed ozone to the macro for a abt 3 months, no problem. I doubt those hose is of ozone proof material. I've upgraded my skimmer, nt sure what will be the long term effect on macro NW.

[dradttg]

Thanks bro.

Now I dont have to work up in the middle of the night to see if my skimmer is leaking. keke

[dradttg]

Dear all,

Need your expert advise again.

I am feeling the skimmer directly (at point D) via a hose from the Ozonizer. The Ozonizer is being fed by a pump.

I notice that the water level in the skimmer is not stable. About every 30 sec, the water level will drop and then rise back to the original level again.

Can you tell me what is the purpose of point C?

Thank you.

[dradttg]

For the benefit of anyone that is using the same skimmer.

Point C should be covered using a small tap to use fine adjustment of water level. Otherwise the water level may fluctuation up and down.

The water pump should be rise higher for better air intake. The picture given at the Macro website is not accurate.