Jump to content

New Maroon clown intro


Recommended Posts

  • SRC Member

Hi Reef gurus....

Nee help here on how to introduce new maroon clown into the family....

Currently having one size 2 inch constantly attacking the new maroon member....

Afraid of the adaptibilities of this new member, now i have use a betta tank to isolate..both of them....

Help & advice....

Thanks.

Tank : 3 x 2 x 1.8 ( setup end Feb 2014 ) --> 4 x 2 x 1.8 ( setup early Nov 2016 )
Skimmer : Bubble Magus NAC6 --> Bubble Magus Curve 7
Return pump : Jebao 10000l/h ( down in 17th December 2014 ) --> Jebao DC-12000 ( 19th December 2014 )
Compressor drop-in coil
Wavemaker : Tunze 6105 x 1
Lights : Modular based DIY LED light x 4

Chaeto in the sump

Link to comment
Share on other sites

Hi Reef gurus....

Nee help here on how to introduce new maroon clown into the family....

Currently having one size 2 inch constantly attacking the new maroon member....

Afraid of the adaptibilities of this new member, now i have use a betta tank to isolate..both of them....

Help & advice....

Thanks.

Paring Premnas species clownfish (maroon clownfish):

Pairing maroon clowns is much more problematic than pairing Amphiprion species clownfish. Maroons are notorious for being very aggressive towards other clownfish. They are pretty much fearless and will only back down from an all out fight when presented with the overwhelming threat of death.

Separation Technique:

The only technique I am aware of that works the vast majority of the time with the least amount of damage as possible to use a separation and slow acclimation process to introduce a poetical mate to a maroon clownfish.

First you need to have a large female already established in your tank before trying a pairing. The clownfish should be at least 3� from nose to start of the cardinal fin. Next you will need to do a little preparation before buying a potential mate for your maroon. You need something to securely separate the two fish in the same tank while still allowing the fish to see each other and the new fish to get water flow. You can use a clear plastic specimen container with holes drilled in it for example.

Now go to the LFS and find the smallest juvenile maroon from a community tank that you can find. It should be no larger than 1� nose to start of cardinal fin. Acclimate the new maroon just as you would any other fish. Once the new maroon is acclimated to your tanks water, place the new maroon in the specimen container. Let the two fish see each other, place the specimen container near the females territory. Carefully watch the female’s behavior. If she is trying to attack the new fish thru the container, it is not safe to release the new maroon. Give her time to cool off from the disruption to her tank and addition of a foreign clownfish in her tank.

Now that the female has cooled her temper it is time to try an introduction. Get your favorite fish net ready and release the new maroon to the tank. If the fighting gets too bad you will need to rescue the new maroon and place it back in the container and try the next day. If after three failed attempts you can write off the new maroon as incompatible and you will need a new juvenile to try with.

for more information u can look up at reefcentral.

http://www.reefcentral.com/forums/forumdisplay.php?f=36

5x2.5x1.5ft Rimless Dream Tank (06/03/12)
Skimmer - Reefoctupus

Return Pump - 1 x Eheim 1264, 1 x water blaster 7k
Wavemaker - 2 x mp40es
Chiller - Daikin compressor with coil drop in
Lighting - 4 x 80w T5 Pair 1(6hrs23/12/12),Pair 2(16/06/12312hrs 2 x 80w De-lighting Retrofit (1/3/12) -(15/11/12)6hrs and 2 x 80w De-lighting Retrofit (13/10/12) -6hrs)
Reactor - Dosing pump (01/01/11)


Link to comment
Share on other sites

  • SRC Member
Paring Premnas species clownfish (maroon clownfish):

Pairing maroon clowns is much more problematic than pairing Amphiprion species clownfish. Maroons are notorious for being very aggressive towards other clownfish. They are pretty much fearless and will only back down from an all out fight when presented with the overwhelming threat of death.

Separation Technique:

The only technique I am aware of that works the vast majority of the time with the least amount of damage as possible to use a separation and slow acclimation process to introduce a poetical mate to a maroon clownfish.

First you need to have a large female already established in your tank before trying a pairing. The clownfish should be at least 3� from nose to start of the cardinal fin. Next you will need to do a little preparation before buying a potential mate for your maroon. You need something to securely separate the two fish in the same tank while still allowing the fish to see each other and the new fish to get water flow. You can use a clear plastic specimen container with holes drilled in it for example.

Now go to the LFS and find the smallest juvenile maroon from a community tank that you can find. It should be no larger than 1� nose to start of cardinal fin. Acclimate the new maroon just as you would any other fish. Once the new maroon is acclimated to your tanks water, place the new maroon in the specimen container. Let the two fish see each other, place the specimen container near the females territory. Carefully watch the female’s behavior. If she is trying to attack the new fish thru the container, it is not safe to release the new maroon. Give her time to cool off from the disruption to her tank and addition of a foreign clownfish in her tank.

Now that the female has cooled her temper it is time to try an introduction. Get your favorite fish net ready and release the new maroon to the tank. If the fighting gets too bad you will need to rescue the new maroon and place it back in the container and try the next day. If after three failed attempts you can write off the new maroon as incompatible and you will need a new juvenile to try with.

for more information u can look up at reefcentral.

http://www.reefcentral.com/forums/forumdisplay.php?f=36

Hi bro....

Thanks for the advice.....

Currently i'm doing that....

Tank : 3 x 2 x 1.8 ( setup end Feb 2014 ) --> 4 x 2 x 1.8 ( setup early Nov 2016 )
Skimmer : Bubble Magus NAC6 --> Bubble Magus Curve 7
Return pump : Jebao 10000l/h ( down in 17th December 2014 ) --> Jebao DC-12000 ( 19th December 2014 )
Compressor drop-in coil
Wavemaker : Tunze 6105 x 1
Lights : Modular based DIY LED light x 4

Chaeto in the sump

Link to comment
Share on other sites

i see, good luck with the pairing. =)

5x2.5x1.5ft Rimless Dream Tank (06/03/12)
Skimmer - Reefoctupus

Return Pump - 1 x Eheim 1264, 1 x water blaster 7k
Wavemaker - 2 x mp40es
Chiller - Daikin compressor with coil drop in
Lighting - 4 x 80w T5 Pair 1(6hrs23/12/12),Pair 2(16/06/12312hrs 2 x 80w De-lighting Retrofit (1/3/12) -(15/11/12)6hrs and 2 x 80w De-lighting Retrofit (13/10/12) -6hrs)
Reactor - Dosing pump (01/01/11)


Link to comment
Share on other sites

  • SRC Member
i see, good luck with the pairing. =)

Thanks bro.....

Hope able to broadcast my success in these few days.....

Tank : 3 x 2 x 1.8 ( setup end Feb 2014 ) --> 4 x 2 x 1.8 ( setup early Nov 2016 )
Skimmer : Bubble Magus NAC6 --> Bubble Magus Curve 7
Return pump : Jebao 10000l/h ( down in 17th December 2014 ) --> Jebao DC-12000 ( 19th December 2014 )
Compressor drop-in coil
Wavemaker : Tunze 6105 x 1
Lights : Modular based DIY LED light x 4

Chaeto in the sump

Link to comment
Share on other sites

  • SRC Member
Thanks bro.....

Hope able to broadcast my success in these few days.....

Hi there....

Just want to updates that my maroon pairing still not successful.

The old maroon still non-stop chasing this new member once release into the tank....

Think need to let it stay in the betta tank for longer period before introduce again....

Do you think if intro during the night (whole dark place).

Any suggestion.

Tank : 3 x 2 x 1.8 ( setup end Feb 2014 ) --> 4 x 2 x 1.8 ( setup early Nov 2016 )
Skimmer : Bubble Magus NAC6 --> Bubble Magus Curve 7
Return pump : Jebao 10000l/h ( down in 17th December 2014 ) --> Jebao DC-12000 ( 19th December 2014 )
Compressor drop-in coil
Wavemaker : Tunze 6105 x 1
Lights : Modular based DIY LED light x 4

Chaeto in the sump

Link to comment
Share on other sites

dont let the big maroon establish its territory......u have to take the risk...mine chased and fought....the male clown was beaten badly but recovered and they are together happily and after...

Tank : 4 X 2 X 2 with low iron front panel and external overflow

Skimmer : BK SM200 with waste collector

Return Pumps : Red Dragon 6m3 and Ehiem 1262

FR : 2 X Deltec 509 & powered by AB2000

Nitrate Filter : Deltec NF 509 and tee off from AB2000

Calcium R'tor : Deltec PF 501 with RM secondary chamber

Kalkwasser R'tor : Deltec KM500

Chiller : Pansonic 1 HP Compressor with 20m titanium Coil

Wave Makers : 4 X Tunze 6055 with 7096 & Vortec MP40w

Controller : GHL Profilux

Lighting : ATI Powermodule 10 or 8 tubes

Water Top-up : Water Top-Up tank powered by Tunze Osmolator

External Monitor : American Pinpoint pH and Temp. Monitor for main tank and GHL Profilux Controller to measure temp, pH, Redox

Ozonizer : Sander C50

UV : Corallife 6x

Algae Scrubbler

Link to comment
Share on other sites

  • SRC Member
dont let the big maroon establish its territory......u have to take the risk...mine chased and fought....the male clown was beaten badly but recovered and they are together happily and after...

Did you intro the maroons at the same time...

My maroon has been there for couple of weeks before this new member arrived.....

Tank : 3 x 2 x 1.8 ( setup end Feb 2014 ) --> 4 x 2 x 1.8 ( setup early Nov 2016 )
Skimmer : Bubble Magus NAC6 --> Bubble Magus Curve 7
Return pump : Jebao 10000l/h ( down in 17th December 2014 ) --> Jebao DC-12000 ( 19th December 2014 )
Compressor drop-in coil
Wavemaker : Tunze 6105 x 1
Lights : Modular based DIY LED light x 4

Chaeto in the sump

Link to comment
Share on other sites

  • SRC Member
Did you intro the maroons at the same time...

My maroon has been there for couple of weeks before this new member arrived.....

Hi guys....

Updates you guys....

New member maroon intro FAIL.... :cry2:

Tank : 3 x 2 x 1.8 ( setup end Feb 2014 ) --> 4 x 2 x 1.8 ( setup early Nov 2016 )
Skimmer : Bubble Magus NAC6 --> Bubble Magus Curve 7
Return pump : Jebao 10000l/h ( down in 17th December 2014 ) --> Jebao DC-12000 ( 19th December 2014 )
Compressor drop-in coil
Wavemaker : Tunze 6105 x 1
Lights : Modular based DIY LED light x 4

Chaeto in the sump

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



×
×
  • Create New...