Ca Reactor

[mv3i]

hi guys ,

Would like to check w all those using CA reactor :

IS it normal for the CO2 input into the bubble counter to slow down gradually ?? Well, mine did ??? So ?? anyone can help ??

[BarraCudaTM]

yr CO2 pressure is getting low...

[mv3i]

that's a new bottle .... still showing about 1200 Lb/in2 on the gauge .... when i open the regulator more, the bubbles increase ( of course lah ) but still after 20/30 mins the same thing happen ... .... is it the regulator/CO2 tank being faulty ??

[Hon]

mv3i,

The irregular pressure might be due to your gas regulator being of poorly made. Are you using a dual guage or just a single guage regulator?

I had the same problem when i was using a single guage regulator of $45. Now I using an AB dual guage regulator, all these problem disappear.

[mv3i]

mv3i,

The irregular pressure might be due to your gas regulator being of poorly made. Are you using a dual guage or just a single guage regulator?

I had the same problem when i was using a single guage regulator of $45. Now I using an AB dual guage regulator, all these problem disappear.

i reckon that too ....

[Hon]

try tune up very little and wait. If not enough bubble count, tune a little more and wait again. Don't do drastic tuning, becoz everytime you do that, its back to square one. Slowly tune up each time and wait until you get the correct bubble count.

[mv3i]

try tune up very little and wait. If not enough bubble count, tune a little more and wait again. Don't do drastic tuning, becoz everytime you do that, its back to square one. Slowly tune up each time and wait until you get the correct bubble count.

been doing that the whole night .... getting there ....