boxfish

just my luck.. maybe anemone too small for this guy cute felle actually but too bad 8-character not match with anemone caught the felle today..place it somewhere else for a while to see if the anemone will recover

I'm sure is not the water problem ... perhaps is the different shrimp we are having... actually when I saw this shrimp at the LFS it was also "hassessing" one purple tip anemone but I thought may be it won't happen to mine.... this is the type..

after adding macro algae, NO3 maintain at ard 5ppm.... grape type tends to turn white ...got the thin-grass type from SL

ever since this felle is added the anemone is in the shrunk state thought it was an anemone's shrimp... ~!@#$

any sandshifting goby?

a layman's view MH is like a sun over the tank whenever I look up from bottom of tank... anyway 1x150W raise 1 degree in my case

roughly how much a piece?

actually along jalan besar opposite Sungei road, near to SimLim square, also have one shop....but the lady boss very the not user friendly cos if you ask her to cut smaller pieces she show black face..... refuse to cut I can accept but pay $$ still must see black face... boycott!

does this coral has same requirement as meat coral? if yes than put it at a low flow low-medium light spot... my prata becomes pandan cake after switched to a good spot.

Correction..art friend got sell own time own target..good place to get acrylic

Is plastic.. seems quite alright

if wet skimmate needs to drain off frequently and dry ones difficult to clean.. err how about not so wet or dry?

can bros who have bought and use this product pls give your verdict..

can't find any acrylic at art friend...

how about those rings for binding books ? where to get those industrial trunking?

where is polyart?

thanks rockfish. how many time have you tasted your tank water?

Tested the overflow without the surface skimming portion just to make sure water flow rate is ok but water flow is very slow if I use ###### for initial start..... why? Then I remove the U-turn ###### output portion and tried with just the basic siphon and water flow was like a tap....while the water is still flowing, I put back the U portion and waterflow was reduced by 20-30% but at least much better than using ###### method. However this is a very awkward method ... reminds me of the nightmare when I was using Eheim filter... I suppose the ###### method can't fill the entire tube with water that's why the flow is low? Also tested initial start with a taller tube for the "end-cap" portion but can't start... Can the expert enlighten me? is there a better method? If the ###### method works for you, pls advice what to look out for during the process. Thanks

Hi, As suggested by one of the reefers, if teh portion with the end-cap is higher than the overflow portion, can I just pour water in instead of ######? Also if I replace the end cap with a ball valve then I can close the valve (not totally) for better flow? anyone tested?

will the fan swing about? looks a bit messy leh... may be difficult to maintain...as in touch one thing hit another thing

maybe enjoying Thai massage

have u started with rowa? how's the result.... by the way, will urchin eat coraline on the LR? how to make sure urchin control coraline properly?

is once a week sufficient? or are they able to make sufficient food themselves?

so you confirm not coraline? Oops..

but it is a bit different from those lighter color type right? this felle a bit slow-motion even the mandarin and CS can walk all over it with own sweet time