calvinci

yupp.

anyone know where I can get KSP5000 230v pump? to replace my euroreef 110v pump.

I use ozone generator for this purpose, it's shinning light beige color after 3 hrs.

so how is this settled? I got a friend run into the same problem, any solution?

white.. ok... but does it disintegrate under water, dissolve easily when pump blow at it?

anyone use the above epoxy before? What's it's color, is it purple or white? And stick well under water?

In my opinion, 27-28 is the best range. As if power failure, temp raise to 30, still not too bad, only 2 degree C different. But if it's 24 and raise to 30, 6 degree C different might cause disaster.

I change 2 of my BLV 10KK to 14KK recently, and lower the light some more. No bleeching, color is definately very white, SPS flourence more now.

yes, that's what I need, PM sent to you..

hi bro, I bought this fluidised reactor during aquarama time, the offer one at S$60 with height about 15" and diameter 3". I need few more but can't remember from whom I bought it already. Anyone bought a similar one and mind to provide supplier name and contact number?

thanks for the tips.

one question, I can't take out the coral and LR, so can the super glue gel being use underwater?

how about acro crab? what size crab has been settled? Can take side body pix of the fish?

I have both deltec and aquaz, in my experience, aquaz won't dissolve under water, but very smelly, deltec quite soft, milky like when under water. Both also won't stick. How do you stick it well? I have acro frag, tried to put the epoxy between it and LR, then I push it against LR and hold, won't stick leh..

the ###### one is purple color one right? I have the same problem. Can those super glue gel stick under water or not?