Advice on DIY beamsworks

[Kawai]

Hi Guys,

Currently using beamswork 9x 1watt lightset for my nano but find the light too white, anyone had success on diying blue led on to it ? currently has 6 white 3 blues. Any advice how do I go about adding blue led to it ?

[Evolutionz]

i think the LEDs are not only solder but also glued to the board. not easy to swap the LEDs.

[Kawai]

i think the LEDs are not only solder but also glued to the board. not easy to swap the LEDs.

how about adding more leds into the board ??? instead of swapping it

[idle69]

If u add more led, u will nid 2 increase de resistor value if not all de led will appear dimmer..worst is no light at all..if i remember correctly, diff colour of led require diff resistor value..

[sherman]

Get additional blue led light set unless you know how to do surface mount soldering

[Firestarter]

You can pry open the white bulb and solder on a blue bulb instead. But be prepared to lose the white bulb as it is glued quite firmly on the board.

[Kawai]

Sounds quite difficult to Diy. Maybe i should just get those blue led strip and paste it on. Any got these type of led strip to recommend? <br /><br />Sent from my LG-P970 using Tapatalk 2<br /><br />

[Firestarter]

You can get those at sim lim tower.

[Kawai]

Those in simlim Sq is suitable for corals also??? If so I will drop by simlim Sq and ask around. <br /><br />Sent from my LG-P970 using Tapatalk 2<br /><br />

[qingwen]

if possible, just add another light? or buy a suitable set and sell away the current set. sold as is lightsets are usually more difficult to diy and make changes to it.

[sheristopher]

I tried open up beamswork before. Really hard to diy out of it.