Where can I get 1 inch PVC "Y" joints

[hamannbmw]

As above.

Call up Hai Cheong and they dont bring in such joints. Anyone knows ??

[apollo]

try this link

http://www.sgreefclub.com/forum/index.php?...topic=37310&hl=

[hotlemond]

try this link

http://www.sgreefclub.com/forum/index.php?...topic=37310&hl=

eh.., this is a Y check valve

[hamannbmw]

I'm not looking for check valve lar

[weileong]

MD55 might not be sufficient to run 2 becketts at the same time.

[hamannbmw]

MD55 might not be sufficient to run 2 becketts at the same time.

ya, i thought of that also, but wanna give it a try ...keke

[weileong]

well if one MX70 don't drive two beckett injector well then what do you think of one MD55?

[alanseah]

well you can Call up Hai Cheong and ask them to custom make the Y for u...

[cowgum]

I have seen this at my frens place before...

it is custom made or DIY ...

PVC welded together

Good Luck!

[weisoon]

Use a T with 2 pieces 90 degrees elbow lor. Pressure rated pump should not be much affected by the 2 elbows. But do consider weileong's point carefully or you will end up wasting about $8 worth of fittings. Can try if you really want.

[chrisyew]

Think you may try C328 - there are plenty of joints there. Seen a few there before but not sure of the sizes (diameter).